Impulse High Flow Vertical adapter Isolation Mod. (HFV)

This is what people are looking for, why. It has multiple functions and without the worries of tapping your Impulse body.

  • Its an adapter so you can mount a ASA gadget grip or vertical reg. to your Impulse.
  • This is referred to as an isolation mod. Why, well it separates the 2 chambers (solenoid& valve) and does not allow the gun to deplete the solenoid air reserve when its needed most, when you fire your marker.
  • NO tapping required, at all.
  • Just install the small air bleed screw and install the rest of the assembly and you will be on your way.
  • It is anodized per the above shown colors. Blue, Green, Purple, Silver Red and Black.
  • Once installed, you can dry fire the gun to clear paint, and it will cycle the bolt and not get held wide open to drain you air tank.
  • O-ring and hardware included.
  • Has a revised high flow air screw for no regulator honk while allowing the best possible flow rate.

*Available in Red, Black, Green, Purple, Blue & Silver.

Also available in 15° angled version

Impulse High Volume Valve Cap
(HVVC)

Currently these are only available the smooth styles seen.  Can help get rid of or reduce bolt stick just from the valve cap alone. These hold more than double the volume of your stock valve cap.

  • Testing shows velocity increases. Users of HPA can see a 15-25fps increase. Co2 results are less.
  • Higher volume means you can run a lower operating pressure
  • Using our high volume cap alone on a stock Impulse can eliminate or reduce bolt stick completely during dry firing
  • These volumizers hold 19.6cc versus the stock capacity of only 9.6cc.
  • Its much lighter than stock
  • Comes with O-ring

*Available in Red, Black, Green, Purple, Blue & Silver.

Impulse LPR
High Volume Valve Cap Kit (HVVC)

These kits do not include a regulator, however we are working on one. The caps are available in the 3 styles seen. Smooth, 3 and 5 Rib design.  Anodized per photo.  Blue, Green, Purple, Silver, Red and Black. Includes the screw in solenoid chamber nipple for 1/8" cocker hose. Comes with all necessary O-rings.  Sorry not available in Gold.

  • Testing shows velocity increases. Users of HPA can see a 15-25fps increase. Co2 results are less.
  • LPR setups make for a more consistent and efficient package.
  • Allows you to adjust bolt pressure to help eliminate chopping.
  • Using the cap alone on a stock Impulse will allow you to dry fire without keeping the bolt hung open.
  • These volumizers hold 19.6cc versus the stock capacity of only 9.6cc.
  • Its a bit lighter, it all adds up to a marker that will be a top choice.
  • 1/8" pipe thread for adding an adjustable regulator.

Check back with us soon...
Home   |   Back   |   Next