SFT Shocker Low Pressure Firing Can

If you have a stock or a Smart Parts™ HE bolt kit in your 03 Shocker, your in luck. Now you can install one of our high volume firing cans to make your marker run at much lower pressures and or dwell. Users can decrease their dwell and or input pressures up to 40psi. Your not running low pressure, unless you have NDZ inside.

  • Works with HE bolt kit for low pressure and high efficiency operation. Users can expect up to 200+ shots from our firing can alone.
  • Stock bolt users will be able to reduce dwell and or input pressures while increasing shot counts as well, up to 150+ shots
  • Run the lowest input pressures in the industry on a SFT Shocker
  • Low input pressures result in less kick, less noise and less wear
  • Includes 2 side seal firing can o-rings

Installation

The first after market bolt kit to be officially licensed through S.P.

Note: Our HE firing can will work on Shockers that have either no side holes or side holes that will seal with our side o-rings. Designed for stock 03 Shocker side body cut-outs.

*Available Black, Silver, Blue & Red.

SFT Shocker (ULP) Ultra Low Pressure Firing Can

Sealed body Shocker owners, your in luck. Install one of our super high volume firing cans to make your marker run at even lower pressures than our other firing can. Users can decrease their dwell and or input pressures up to 45-50psi. Your not running low pressure unless, you have NDZ inside.

  • Works with HE bolt kit for low pressure and high efficiency operation. Users can expect up to 200+ shots from our firing can alone.
  • Stock bolt users will be able to reduce dwell and or input pressures while increasing shot counts as well, up to 150+ shots
  • Run the lowest input pressures in the industry on a SFT Shocker
  • Low input pressures result in less kick, less noise and less wear
Installation


Note: Our ULP firing will only work on sealed body Shockers, such as the Dynasty, Nasty, Ton-Ton etc. with NO body cut-outs.

*Available in Black, Blue & Red.

NXT? SFT Shocker V3 Stinger (ULP) Ultra Low Pressure Bolt Kit

This bolt kit is for SEALED BODY Shocker only. Simply put, this bolt rocks. The smoothest, lowest pressure, less kick, bolt you can find. Expect shot counts ranging from 1200 to 1300+ shots using a 68/4500 psi tank. Our bolt kit greatly enhances airflow while reducing o-ring friction. Its also an *officially licensed product.

  • ULP fits, NXT Evil, Naughty Dogs, and Dynasty
  • high flow port design for high efficiency operation
  • Revised bolt, 2.6gr. over previous bolt
  • Greatly improved shot count up to 56% more shots on a stock 68/4500psi setup firing 900 shots
  • Lowest input pressure operation avg. of 170psi, even pressures under 160psi are possible
  • Ultra flow, aluminum bolt that's lighter and takes up LESS internal volume for lower input pressures
  • Helps eliminates first shot drop off (FSDO) by reducing friction
  • Ultra smooth operation using low o-ring friction and very smooth surface finishes
  • Increased R.O.F.

Install Instructions

* Technology licensed from Smart Parts Inc.

Note: Our ULP bolt kits will only work on sealed body Shockers, such as the Dynasty, Nasty, Ton-Ton etc. with NO body cut-outs.

*Available in Black, Blue & Red
Home   |   Back   |   Next